RAM Mount iPad Mini Cradle Yoke Mount Handlebar Rail Tripod

The RAM-B-121-AP14U is a full kit that will allow you to mount an iPad Mini onto a handlebar or rail surface.

The RAM-B-121-AP14U consists of the following RAM (B Size) components:

• 1 x RAM EZ-Roll'r™ Cradle for iPad Mini 1-3 WITHOUT CASE, SKIN OR SLEEVE (RAM-HOL-AP14U)
• 1 x RAM 2.5" Round Base with AMPs Hole Pattern and 1" Ball (RAM-B-202U)
• 1 x Double Clamp Arm (Length of your choice - see below)
• 1 x RAM Yoke Clamp Base with 1" Rubber Ball (RAM-B-121BU)

RAM EZ-Roll'r™ Cradle for iPad Mini 1-3 WITHOUT CASE, SKIN OR SLEEVE (RAM-HOL-AP14U)

The RAM-HOL-AP14U consists of a high strength composite cradle and patent pending roller design.

The patent pending roller design allows for smooth placement and removal of the iPad, while keeping it secure while on the go.

Compatible and interchangeable with a wide range of popular RAM Mounting products, this cradle is ready to compliment your iPad and become the most useful accessory in your vehicle.

Included is a set of four nuts and bolts to connect the cradle to any RAM components or mounts that contain the universal AMPs hole pattern.

RAM Double Socket Clamp Arm (Select length prior to checkout);

• SHORT (RAM-B-201U-A) Overall Length: 6cm Socket-To-Socket Length: 4.5cm
• STANDARD (RAM-B-201U) Overall Length: 9cm Socket-To-Socket Length: 7.6cm
• LONG (RAM-B-201U-C) Overall Length: 15cm Socket-To-Socket Length: 13.5cm

RAM Yoke Clamp Base with 1" Rubber Ball (RAM-B-121BU)

The yoke clamp base will fit rails in diameter from 0.625" to a maximum of 1.25".

The 1" rubber ball is at a right angle to the plane of the mount; when connected to a rail, the ball sits parallel to the rail.

Clamp Base Dimensions:

• Accommodates rails from 0.625" to 1.25" in diameter.

** This listing includes one double socket Clamp Arm only. Please select the length required prior to checkout.
* Any device shown is for illustration purposes only and is not included in purchase.